Level 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Before
After
Before
After
Before
AfterOlympia Chimney Chimney Repair in Lawrence: What to Know First
Olympia Chimney repair in Lawrence typically runs $275-$1,200 for most mortar and flashing work, and most flue repairs are done in a single visit. We’re an independent Olympia Chimney service provider, not a factory warranty line, and we’ll tell you straight if the repair can wait. This page is for Lawrence homeowners whose Olympia Chimney setup is showing cracked joints, spalling brick, or water staining near the flue. Call (516) 604-2573 and Wendell or one of the crew will talk you through what you’re seeing, no charge for the conversation.
How Olympia Chimney Products Fail - and How We Fix Them
Olympia Chimney makes solid stainless and galvanized flue components that hold up better than most, but the chimney stack around them takes a beating in Lawrence’s salt air and freeze-thaw winters. Here’s what we actually see on the job, model line by model line.
- Olympia Chimney 6″ and 8″ Round Stainless Liners - joint slip at the tee. The locking bands on Olympia’s round liner sections do their job, but in older Lawrence homes where the original terra cotta tile has shifted, the liner flexes at the tee connection and the pop rivets work loose. We open the cleanout, remove the band, re-secure the joint with a fresh Olympia band or a heavier aftermarket one, and re-test the draw. You’d never spot this from the firebox.
- Olympia Chimney Square and Rectangular Chase Covers - rust through the welded corners. On prefab chase chimneys, the corners are where salt spray from the Atlantic settles and sits. Olympia’s galvanized covers oxidize at the weld seams first, and once water gets through, it drips straight down onto the fireplace framing. We replace the cover with a heavier-gauge stainless cap, bedded in high-temp silicone, and we always check the chase top flashing while we’re up there.
- Olympia Chimney Anchor Plates - loosening at the crown. The anchor plate bolts to the old masonry crown, and on Lawrence homes where the crown has hairline cracking, the plate starts to lift on the sea breeze side. That gap lets water run between the plate and the crown instead of into the liner. We reseat the plate, fill the crown cracks with a flexible crown sealant, and re-bolt. Takes about an hour, saves the ceiling below.
- Olympia Chimney Flashing Kits - step flashing pulling away from the roofline. These kits use standard step flashing, and in Lawrence’s roof ice cycles the flashing moves independently from the chimney. The nails back out, the aluminum curls, and water finds the gap. We strip the old flashing, install new L-shaped flashing cut to the actual roof pitch, and seal the seam with a urethane caulk that flexes instead of cracking.
- Olympia Chimney Rain Caps and Spark Arrestors - mesh clogging from oak and maple leaf litter. This one’s less a failure and more a Lawrence reality. Olympia’s mesh arrestors do catch embers, but they catch wet leaves the same way. A blocked arrestor chokes the flue, smoke backs up, and the creosote load climbs fast. We pull the cap, wire-brush the mesh, and if it’s dented past saving, a Universal replacement from our stock fits most Olympia terminations.
Our Olympia Chimney Chimney Repair Process
Every Olympia Chimney job follows the same order of operations, whether it’s a repointing job on a 1940s brick stack or a chase cover swap on a newer prefab.
- 1
You call (516) 604-2573. A live person answers. You describe what you’re seeing - water stain, spalling brick, a smoky fire. We give you an honest price range before anyone gets in the truck.
- 2
We come out and look. Wendell or one of the crew walks the roof line, checks the firebox, and runs the camera up the flue if there’s any question. You see the footage yourself.
- 3
We decide what’s actually wrong. Sometimes it’s a $40 seal job. Sometimes it’s a crown rebuild. We show you the evidence and give you a written number. No surprise line items.
- 4
We do the work. OEM Olympia parts when it matters, quality aftermarket when it’s genuinely better. We never mix a repair that won’t hold together.
- 5
We test it. Smoke test, draft check, water test on flashing. If it doesn’t breathe right, we’re not done.
- 6
The 90-Day Done Right Promise goes in writing. If the repair fails, one call brings us back at no charge. We’ve been doing this since 1999, and the promise gets used less than you’d expect because we don’t leave a job half right the first time.
What Olympia Chimney Chimney Repair Costs in Lawrence
Repair pricing in Lawrence runs a little higher than in Nassau’s inland towns because the salt corrosion and older housing stock mean repairs rarely stop at the first layer of damage. Here’s what you’re looking at:
- Mortar repointing or tuckpointing: $275-$600 depending on how many joints are open
- Spalling brick replacement: $45-$90 per brick, including mortar bed
- Flashing repair or replacement: $350-$800
- Chimney crown recoat or rebuild: $165-$1,200 depending on cracking and size
- Chase cover replacement (stainless): $300-$850 sized to the chase
- Chimney waterproofing: $250-$500 for a full application
What moves the price is height, access, and how long the damage has been sitting. A first-floor roof with a ladder is one number. A three-story gable in the wind is another. We give you the number before a tool comes off the truck, and the estimate is free. Call (516) 604-2573 if you want a real number for your chimney.
Why Lawrence Homeowners Call Top Hat Chimney for Olympia Chimney Work
Lawrence is a small enough town that the same names keep showing up on job tickets, and ours has been on plenty since 1999. Wendell Pike started this company with a truck and a brush, and he still answers the phone half the time. The license number is published, the address is real, and the guy who inspects your chimney is probably the same guy you waved at outside the hardware store last weekend. If your Olympia chimney needs a liner or cap work and we’re laying hands on it, you get the same care we give a full rebuild. We stock DuraFlex, HeatShield, and Gelco for cases where Olympia components aren’t the right fit, but we’ll never sell you a switch you don’t need. Ask anyone on your street. Better yet, call and ask Wendell yourself.
FAQs About Olympia Chimney Chimney Repair in Lawrence
Maybe. Olympia’s warranty covers manufacturing defects in their stainless steel products, not the mortar, crown, flashing, or weather damage around them. We’re an independent provider, so we don’t process Olympia warranty claims, but we’ll show you exactly what failed and why, and you can take that straight to the manufacturer if the defect is theirs. If it’s labor or weather damage, we’ll quote the fix honestly.
Yes. Most Olympia Chimney repair in Lawrence involves the chimney structure around the product, which has nothing to do with manufacturer authorization. We use OEM Olympia parts when they’re the right call and quality aftermarket parts when they’re better. The repair work itself carries our 90-Day Done Right Promise, in writing, on every job.
Chimney repairs in Lawrence aren’t emergency calls like a gas leak, but water damage doesn’t wait either. During fall and early winter, we’re typically out within a few days, and the repair is usually done in one visit. If you’re seeing water in the firebox after a storm, call (516) 604-2573 and we’ll work you in.
That depends on what the camera shows. A slipped joint or a failed band can be repaired in place. A liner that’s rusted through or separated at the seam needs replacing. We’ll show you the footage and give you our honest read. As independent service providers, our job is to keep your chimney safe and working, not to sell a liner swap when a $40 clamp would do. Call (516) 604-2573 for a free estimate either way.
Water keeps moving through open mortar joints and cracks, and freeze-thaw cycles in Lawrence winters widen them every season. Spalling brick gets worse, flashing lifts further, and that little $275 repoint becomes a $1,200 crown rebuild. Chimneys break in the off-season too, so once a year, burn or no burn. If you’re not sure whether you even have a problem, call us. If it’s clean, Wendell will tell you it’s clean.
Written by Wendell Pike, Owner, Top Hat Chimney, serving Lawrence and nearby areas.